Numerical Simulation and Experimental Study on the Gas-liquid Two-phase Flow in the Pump During the Gas Cut-off Transition Process

Document Type : Regular Article

Authors

1 College of Mechanical and Power Engineering, Nanjing Tech University, Nanjing 211816, Jiangsu, China

2 College of Emergency Management, Nanjing Tech University, Nanjing 211816, Jiangsu, China

10.47176/jafm.18.8.3337

Abstract

This study aims at elucidating the flow mechanism and characterizing the internal pump flow properties during the gas cut-off transition process. High-speed photography (HSP) served for visualizing the flow patterns within a transparent centrifugal pump model fabricated from plexiglass. Numerical simulation was conducted on the gas-liquid two-phase flow within the pump in the gas cut-off transition process using the Eulerian-Eulerian heterogeneous flow model coupled with the SST k-ω turbulence model. The experimental observations from HSP served as validation for the numerical simulation results. During the gas cut-off transition process, with a decreasing gas volume fraction (GVF), the pressure in the volute gradually increases until it ultimately exhibits periodic variation. The time-averaged pressure exhibits a steady increase with the flow. The GVF slowly diminishes along volute’s radial direction. As a consequence of impeller rotation, the outlet pressure rises with the decreasing integral rate of the gas phase inside the impeller. Concurrently, the integral rate at the outlet has not yet changed, so the change in outlet GVF consistently lags behind the change in outlet pressure. The centrifugal pump completes the gas cut-off transition process when fluctuations in the outlet GVF cease. This investigation revealed the temporal evolution of GVF and pressure during the centrifugal pump's gas cut-off transition process, and established a quantitative criterion for determining the completion of this process. The research results are beneficial for more deeply comprehending the pump's performance, and well contribute to the reliable operation and structural optimization pertaining to centrifugal pumps. 

Keywords

Main Subjects


Chalghoum, I., Elaoud, S., Akrout, M., & Taieb, E. H. (2016). Transient behavior of a centrifugal pump during starting period. Applied Acoustics, 109, 82-89. https://doi.org/10.1016/j.apacoust.2016.02.007
Feng, J. J., Ge, G., Zhang, Y., Zhu, G. J., Wu, G. K., Lu, J. L., & Luo, X. Q. (2021). Numerical investigation on characteristics of transient process in centrifugal pumps during power failure. Renewable Energy, 170, 267-276. https://doi.org/10.1016/j.renene.2021.01.104
Feng, J. J., Zhang, Y., Zhu, G. J., Li, Y. Z., Li, W. F., & Luo, X. Q. (2020). Transition process characteristics of centrifugal pump with power-off based on entropy production theory. Transactions of the Chinese Society of Agricultural Engineering, 36(4), 10-17. https://doi.org/10.11975/j.issn.1002-6819.2020.04.002
Fu, S. F., Zheng, Y., Kan, K., Chen, H. X., Han, X. X., Liang, X. L., Kiu, H. W., & Tian, X. Q. (2020). Numerical simulation and experimental study of transient characteristics in an axial flow pump during start-up. Renewable Energy, 146, 1879-1887. https://doi.org/10.1016/j.renene.2019.07.123
Ge, Z. G., He, D. H., Huang, R., Zuo, J. L., & Luo, X. Q. (2020). Application of CFD-PBM coupling model for analysis of gas-liquid distribution characteristics in centrifugal pump. Journal of Petroleum Science and Engineering, 194, 107518. https://doi.org/10.1016/j.petrol.2020.107518
He, D. H., Ge, Z. G., Bai, B. F., Guo, P. C., & Luo, X. Q. (2020a). Gas-liquid two-phase performance of centrifugal pump under bubble inflow based on computational fluid dynamics-population balance model coupling model. Journal of Fluids Engineering, 142(8), 081402. https://doi.org/10.1115/1.4047064
He, W. T. (2020b). Numerical simulations on gas-liquid two-phase flow characteristics of centrifugal pumps with models considering for different bubbles variations. Zhen Jiang, Jiangsu University. https://doi.org/10.27170/d.cnki.gjsuu.2020.001519.
Jia, X. Q., Yuan, S., Zhu, Z. C., & Cui, B. L. (2019). Numerical study on instantaneous radial force of a centrifugal pump for different working conditions. Engineering Computations, 37(2), 458-480. https://doi.org/10.1108/EC-04-2019-014
Kan, K., Zheng, Y., Chen, X., Zhou, D. Q., Dai, J., Binama, M., & Yu, A. (2020). Numerical simulation of transient flow in a shaft extension tubular pump unit during runaway process caused by power failure. Renewable Energy, 154, 1153-1164. https://doi.org/10.1016/j.renene.2020.03.057
Kim, J. H., Cho, B. M., Kim, S., Lee, Y. K., & Choi, Y. S. (2019). Detailed flow characteristic analysis of a three-stage centrifugal pump at design and off-design conditions. IOP Conference Series: Earth and Environmental Science, 240, 092004. https://doi.org/10.1088/1755-1315/240/9/092004
Lee, H. C., Yoo, I. S., Kim, J. H., Kim, J. Y., Yoon, J. Y., Choi, W. C., & Choi, Y. S. (2015). Improvement of hydrodynamic performance of a multiphase pump using design of experiment techniques. ASME. Journal of Fluids Engineering, 137(8), 081301. https://doi.org/10.1115/1.4029890
Li, D. Y., Wang, H. J., Li, Z. G., Nielsen, T. K., Goyal, R., Wei, X. Z., & Qin, A. Q. (2017). Transient characteristics during the closure of guide vanes in a pump turbine in pump mode. Renewable Energy, 118, 973-983. https://doi.org/10.1016/j.renene.2017.10.088
Li, W., Zhang, Y., Shi, W. D., Ji, L. L., Yang, Y. F., & Ping, Y. F. (2018). Numerical simulation of transient flow field in a mixed-flow pump during starting period. International Journal of Numerical Methods for Heat & Fluid Flow, 28(4), 927-942. https://doi.org/10.1108/HFF-06-2017-0220
Li, X. J., Chen, B., Luo, X. W., & Zhu, Z. C. (2020). Effects of flow pattern on hydraulic performance and energy conversion characterisation in a centrifugal pump. Renewable Energy, 151, 475-487. https://doi.org/10.1016/j.renene.2019.11.049
Li, X. J., Yuan, S. Q., Pan, Z. Y., Li, Y. L., & Yan, J. (2012). Realization and application evaluation of near-wall mesh in centrifugal pumps. Transaction of the Chinese Society Agricultural Engineering, 28(20), 67-72.
Liu, H. L., Wang, Y., Liu, D. X., Yuan, S. Q., & Wang, J. (2013). Assessment of a turbulence model for numerical predictions of sheet-cavitating flows in centrifugal pumps. Journal of Mechanics science and Technology, 27(9), 2743-2750. - https://doi.org/10.1007/s12206-013-07208
Olimstad, G., Osvoll, M., & Finstad, P. H. E. (2018). Very low specific speed centrifugal pump-hydraulic design and physical limitations. ASME. Journal of Fluids Engineering, 140(7), 071403. https://doi.org/10.1115/1.4039250
Parikh, T., Mansour, M., & Thévenin, D. (2020). Investigations on the effect of tip clearance gap and inducer on the transport of air-water two-phase flow by centrifugal pumps. Chemical Engineering Science, 218, 115554. https://doi.org/10.1016/j.ces.2020.115554
Rezghi, A., & Riasi, A. (2016). Sensitivity analysis of transient flow of two parallel pump-turbines operating at runaway. Renewable Energy, 86, 611-622. https://doi.org/10.1016/j.renene.2015.08.059
Shao, C. L., He, A. X., Zhang, Z. Y., & Zhou, J. F. (2019). Study on the transition process of a molten salt pump transporting media with crystalline particles by modeling test and numerical simulation. International Journal of Numerical Methods for heat &Fluid Flow, 29(9), 3263-3289. https://doi.org/10.1108/HFF-12-2018-0807
Shao, C. L., Zhou, J. F., & Cheng, W. J. (2015). Experimental and numerical study of external performance and internal flow of a molten salt pump that transports fluids with different viscosities. International Journal of Heat and Mass Transfer, 89, 627-640. https://doi.org/10.1016/j.ijheatmasstransfer.2015.05.087
Wang, J., Wang, Y., Liu, H. L., Si, Q. R., & Dular, M. (2018). Rotating corrected-based cavitation model for a centrifugal pump. ASME. Journal of Fluids Engineering, 140(11), 11301. https://doi.org/10.1115/1.4040068.
Wang, Y., Chen, J., Liu, H. L., Shao, C., & Zhang, X. (2017). Transient characteristic analysis of ultra-low specific-speed centrifugal pumps during startup period under shut-off condition. Transactions of the Chinese Society of Agricultural Engineering, 33(11), 68-74. https://doi.org/10.11975/j.issn.1002-6819.2017.11.009
Yan, S. N., Luo, X. Q., Zhang, L. F., Feng, J. J., Zhu, G. J., Chen, S. L., He, D. H., & Li, C. H. (2019). Influence of inlet gas volume fraction on performance of a gas-liquid centrifugal pump. IOP Conference Series: Earth and Environmental Science, 240, 062059. https://doi.org/10.1088/1755-1315/240/6/062059
Yu, Z. Y., & Liu, Y. (2013). Characteristic analysis of unsteady gas-liquid two-phase flow in a multiphase rotodynamic pump. Transactions of the Chinese Society for Agricultural Machinery, 44(5), 66-69. https://doi.org/10.6041/j.issn.1000-1298.2013.05.013
Yuan, J. P., Zhang, K. Y., Si, Q. R., Zhou, B. L., Tang, Y. F., & Jin, Z. K. (2017). Numerical investigation of gas-liquid two-phase flow in centrifugal pumps based on inhomogeneous model. Transactions of the Chinese Society for Agricultural Machinery, 48(1), 89-95. https://doi.org/ 10.6041/j.issn.1000-1298.2017.01.012
Zhang, Y. (2020). Study on transient characteristics of centrifugal pumps during power-off runaway transient process. Xi An, Xi’an University of Technology. https://doi.org/10.27398/d.cnki.gxalu.2020.000473
Zhang, Y. L., Xiao, J. J., Cui, B. L., & Zhu, Z. C. (2014). Simulation of transient behavior in prototype centrifugal pump during rapid regulating flow rate. Transactions of the Chinese Society of Agricultural Engineering, 30(11), 68-75. https://doi.org/10.3969/j.issn.1002-6819.2014.11.009
Zhang, Y. L., Zhu, Z. C., Cui, B. L., Li, Y., & Tao, H. R. (2012). Numerical simulation of unsteady flow in centrifugal pump during stopping period. Journal of Engineering Thermophysics, 33(12), 2096-2099.
Zhao, L., Chang, Z., Zhang, Z. D., Huang, R., & He, D. H. (2021). Visualization of gas-liquid flow pattern in a centrifugal pump impeller and its influence on the pump performance. Measurement: Sensors, 13, 100033. https://doi.org/10.1016/j.measen.2020.100033
Zhao, W. G., & Zhao, G. S. (2018). Numerical investigation on the transient characteristics of sediment-laden two-phase flow in a centrifugal pump. Journal of Fluid Mechanics science and Technology, 32(1), 167-176. https://doi.org/10.1007/s12206-017-1218-6
Zhou, L., Han, Y., Lv, W. N., Yang, Y., Zhu, Y., & Song X. Y. (2020). Numerical calculation of energy performance and transient characteristics of centrifugal pump under gas-liquid two-phase condition. Micromachines, 11(8), 728-742. https://doi.org/10.3390/mi11080728
Zhou, P. J., Wang, F. J., & Mou, J. G. (2017). Investigation of rotating stall characteristics in a centrifugal pump impeller at low flow rates. Engineering Computations, 34(6), 1989-2000. https://doi.org/10.1108/EC-05-2016-0167