Experimental Investigation of the Flow Resistance Characteristics of Air Vertically Flowing through a Horizontal Tube Bundle with Falling Film Water

Document Type : Regular Article

Authors

State-Local Joint Engineering Research Center of Thermal Energy Comprehensive Utilization Technologies, Dalian University of Technology, Dalian, Liaoning Province, 116024, China

10.47176/jafm.18.10.3427

Abstract

The pressure drops and the friction factor of the air flowing up and down through a horizontal tube bundle with falling film water are investigated in this work, and the effects of air velocity, water spray density and air flow direction are studied. The experiment is conducted on a 13-row horizontal tube bundle with a tube diameter of 38 mm and a total of 33 tubes. The experimental data covers an air velocity range of 2.5~6.4 m/s, a water spray density range of 0.056~0.111 kg/(m·s), an air temperature of 20 °C, an air relative humidity of 60% and a spray water temperature of 30 °C. The pressure drop has a positive relationship with the spray density and air velocity, and the counter flow has a slightly larger pressure loss compared with the cocurrent flow. The proportions of the pressure drop caused by the friction between the air and spray water to the total pressure are observed to increase with the spray density and decrease with the air velocity for both counter and cocurrent flow. These proportions for the two flow patterns are approximately 10~30% for counter flow and 10~25% for cocurrent flow, respectively. Based on experimental data, prediction correlations of the friction factors through horizontal falling film tube bundles are proposed, and the prediction deviation for almost all experimental data is within ±5%.

Keywords

Main Subjects


Anderson, N. R. (2014). Evaluation of the performance characteristics of a hybrid (dry/wet) induced draft dephlegmator [Doctoral dissertation, Stellenbosch University]. https://scholar.sun.ac.za/items/04e87b55-00dc-4abf-8d51-7d2910c2627e
Catrawedarma, I., & Deendarlianto, I. (2020). The performance of airlift pump for the solid particles lifting during the transportation of gas-liquid-solid three-phase flow: a comprehensive research review. Journal of Process Mechanical Engineering, 235(2), 606-628. https://doi.org/10.1177/0954408920951728
Catrawedarma, I., & Deendarlianto, I. (2022). Hydrodynamic behaviors of air-water two-phase flow during the water lifting in a bubble generator type of airlift pump system. Heat and Mass Transfer, 58(6), 1005-1026.
https://doi.org/10.1007/s00231-021-03157-z
Dowlati, R., Chan, A. M. C., & Kawaji, M. (1992). Hydrodynamics of two-phase flow across horizontal in-line and staggered rod bundles. Journal of Fluids Engineering, 114(3), 450-456.
https://doi.org/10.1115/1.2910052
Dowlati, R., Kawaji, M., Chan, A. M. C. (1990). Pitch-to-diameter effect on two-phase flow across an in-line tube bundle. Aiche Journal, 36(5), 765-772.
https://doi.org/10.1002/aic.690360513
Finlay, I. C., Harris, D. (1984). Evaporative cooling of tube banks. International Journal of Refrigeration, 7(4), 214-224.
https://doi.org/10.1016/0140-7007(84)90073-2
Fiorentino, M., Starace, G. (2016). Numerical investigations on two-phase flow modes in evaporative condensers. Applied Thermal Engineering, 94, 777-785.
https://doi.org/10.1016/j.applthermaleng.2015.10.099
Heyns, J. A., Kröger, D. G. (2010). Experimental investigation into the thermal-flow performance characteristics of an evaporative cooler. Applied Thermal Engineering, 30(5), 492-498.
https://doi.org/10.1016/j.applthermaleng.2009.10.010
Kline, S. J.  (1985). The purposes of uncertainty analysis. Journal of Fluids Engineering, 107(2), 153-160.
 https://doi.org/10.1115/1.3242449
Liu, H., Shen, S. Q., Gong, L. Y., Chen, S. (2014). Shell-side two-phase pressure drop and evaporation temperature drop on falling film evaporation in a rotated square bundle. Applied Thermal Engineering, 69(1-2), 214-220.
https://doi.org/10.1016/j.applthermaleng.2013.11.061
Mizushina, T., Ito, R., Miyashita H. (1967) Experimental Study of Evaporative Cooler. Kagaku Kogaku Ronbunshu, 31, 469-473.
https://doi.org/10.1252/KAKORONBUNSHU1953.31.469
Plessis, J. D., Owen, M. (2020). An Experimental Investigation of the Air-Side Pressure Drop Through a Bare Tube Bundle. Journal of Thermal Science and Engineering Applications, 12(1), 011012.
https://doi.org/10.1115/1.4044425
She, Y., Chan, W., Chang, F., Guo, K., Li, H. (2021). Experimental investigation on the characteristics of pressure drop and air/vapor flow over horizontal tube bundle with water-spray falling film. Desalination and Water Treatment, 216, 34-46.
https://doi.org/10.5004/dwt.2021.26818
Skundric, J., Zivkovic, P., Tica, M., Tomic, M., Barz, C. (2023). Investigation of air-cooled condenser's operating parameters in modern thermal power plant. Thermal Science, 27(3B), 2477-2487.
https://doi.org/10.2298/TSCI220806203S
Xu, G. P., Tso, C. P., Tou, K. W. (1998). Hydrodynamics of two-phase flow in vertical up and down-flow across a horizontal tube bundle. International Journal of Multiphase Flow, 24(8), 1317-1342.
https://doi.org/10.1016/S0301-9322(98)00035-4
Zalewski, W., Gryglaszewski, P. A. (1997). Mathematical model of heat and mass transfer processes in evaporative fluid coolers. Chemical Engineering and Processing, 36(4), 271-280.
https://doi.org/10.1016/S0255-2701(97)00006-8
Zhang, P., Guo, B., Wang, L. (2023). An Experimental Study on the Heat and Mass Transfer Characteristics of an Evaporative Cooler. Energies, 16(21), 7330.
https://doi.org/10.3390/en16217330
Žukauskas, A. (1972). Heat Transfer from Tubes in Crossflow. Advances in Heat Transfer, 8, 93-160.
https://doi.org/10.1016/S0065-2717(08)70038-8