Correlation Analysis of the Hydrodynamic Characteristics and Stability of a Self-balancing Multistage Pump

Document Type : Regular Article

Authors

1 Chongqing Pump Industry Co. Ltd. Chongqing, 400000, China

2 School of Energy and Power Engineering, Lanzhou University of Technology, Lanzhou, Gansu Province, 730050, China

10.47176/jafm.18.12.3394

Abstract

The BB5 series multistage centrifugal pump is commonly utilized for its capacity to deliver a large head. However, due to the long rotor system in the BB5 series multistage pump, the unsteady flow field structure of each impeller at every stage inevitably results in more complex mechanical characteristics of the pump, thereby affecting its operational stability. This paper conducts a numerical study on the stability of a 12-stage self-balancing multistage pump. The results indicated that significant pressure load fluctuations on the working surface occurred at the inlet of the impeller blades at all levels in the low-pressure section. At low flow conditions, the coincidence of the pressure loads on different blade working surfaces and back surfaces of the same impeller was poor; this resulted in an inadequate uniformity of the force distribution on each blade. A negative correlation was observed between the intensity of the pressure pulsation and the flow rate. In the inlet section the intensity of pressure fluctuation was stronger than that in the outlet section. The spectrum characteristic diagram of radial force shows that the frequencies with higher amplitudes occurring at each stage impeller are approximately 298 Hz and 48 Hz. The cause is the interference between the impeller blades and the guide vanes. At low flow rates, the amplitude of the radial force of the impeller was significantly higher than that at other flow rates. The magnitude of the residual axial force fluctuated to a certain degree, but its direction remained unchanged. The stability of the flow field and mechanical performance were inferior at low flow rates. At the same flow rate, the stability of the inlet section was worse. These research results could provide references for the stability design and optimization of self-balancing multistage pumps.

Keywords

Main Subjects


Abdelouahab, M. A., Ngoma, G. D., Erchiqui, F., & Kabeya, P. (2020). Numerical study of the axial and radial forces, the stresses and the strains in a high pressure multistage centrifugal pump. International Conference on Simulation and Modeling Methodologies, Technologies and Applications. 181-188. https://doi.org/10.5220/0009783001810188.
Al Tobi, M. A. S., Bevan, G., Ramachandran, K. P., Wallace, P., & Harrison, D. (2017). Experimental set-up for investigation of fault diagnosis of a centrifugal pump. International Journal of Mechanical and Mechatronics Engineering, 11(3), 481-485.
Bai, L., Zhou, L., Jiang, X., Pang, Q., & Ye, D. (2019). Vibration in a multistage centrifugal pump under varied conditions. Shock and Vibration, 2019(1), 2057031. https://doi.org/10.1155/2019/2057031
Cui, B., Li, X., Rao, K., Jia, X., & Nie, X. (2018). Analysis of unsteady radial forces of multistage centrifugal pump with double volute. Engineering Computations, 35(3) (2018) 1500-1511. https://doi.org/10.1108/EC-12-2016-0445
Cui, B., Zhang, Y., Huang, Y., & Zhu, Z. (2022). Analysis of unsteady flow and fluid exciting forces of multistage centrifugal pump based on actual size. Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 236(1), 21-32. https://doi.org/1177/09576509211023222
Deng, X. G., Zong, W. G., Zhang, L. P., Gao, S. C., & Li., C. (2007). Verification and validation in computational fluid dynamics. Advance in Mechanics, 37(2), 279‒288. (in Chinese).
Isametova, M., & Abilezova, G. (2022). Study of the influence of the design of a centrifugal wheel on the pressure characteristics of a multistage pump. MATEC Web of Conferences. EDP Sciences, 366, 01006. https://doi.org/10.1051/matecconf/202236601006.
ITTC (2002a). ITTC QM Procedure, Uncertainty analysis in CFD verification and validation ethodology and procedures. 7.5-03-01-01.
ITTC (2002b). ITTC QM Procedure, Uncertainty analysis in CFD, examples forresistance and flow. 7.5-03-02-01.
Jiang, W., Pei, J., Wang, W., & Yuan, S. (2021). Optimization for first stage of multistage pump based on response surface methodology. IOP Conference Series: Earth and Environmental Science. IOP Publishing, 627(1), 012017. https://doi.org/10.1088/1755-1315/627/1/012017
Kang, Y., Liu, S., Zou, W., & Hu, X. (2019). Numerical investigation on pressure pulsation characteristics and radial force of a deep‐sea electric lifting pump at Off‐design conditions. Shock and Vibration, 2019(1), 4707039. https://doi.org/10.1155/2019/4707039
Kim, D. S., Mamatov, S., Jeon, S. G., & Park, W. G. (2017). A study of the performance of a radial diffuser for a multistage high-pressure pump. Journal of Mechanical Science and Technology, 31, 1693-1700. https://doi.org/10.1007/s12206-017-0317-8
Li, W., Jiang, X., Pang, Q., Zhou, L., & Wang, W. (2016). Numerical simulation and performance analysis of a four-stage centrifugal pump. Advances in Mechanical Engineering, 8(10), 1687814016673756. https://doi.org/10.1177/1687814016673756
Lu, Z., Wang, C., Qiu, N., Shi, W., Jiang, X., Feng, Q., & Cao, W. (2018). Experimental study on the unsteady performance of the multistage centrifugal pump. Journal of the Brazilian Society of Mechanical Sciences and Engineering, 40, 1-10. https://doi.org/10.1007/s40430-018-1157-x
Milovančević, M., Nikolić. V., Petkovic, D. L., Vracar, E., Tomic, Veg. N., & Jović, S. (2018). Vibration analyzing in horizontal pumping aggregate by soft computing. Measurement, 125, 454-462. https://doi.org/10.1016/j.measurement.2018.04.100,2-s2.0-850467060 53.
Peng, G., Hong, S., Chang, H., Zhang, Z., & Fan, F. (2021). Optimization design of multistage pump impeller based on response surface methodology. Journal of Theoretical and Applied Mechanics, 59(4), 595-609. https://doi.org/10.15632/jtam-pl/141939
Qian, C., Luo, X., Yang, C., & Wang, B. (2022). Calculation and verification of balance force of multistage pump balance drum. Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 236(1), 153-164. https://doi.org/
Qian, C., Yang, L. H., Qi, Z. P., Yang, C. X., & Niu, C. H. (2022). Mechanism analysis of double helical balance drum to improve axial force of multistage pump. Modern Physics Letters B, 36(35), 2250185. https://doi.org/10.1142/S0217984922501846
Tan, M., Guo, B., Liu, H., Wu, X., & Wang, K. (2015). Investigation of radial force and hydraulic performance in a centrifugal pump with different guide vane outlet angle. Journal of Vibroengineering, 17(6), 3247-3260. https://www.extrica.com/article/16075
Wang, S., Yang, J., & Xu, G. (2023). Influence of positive guide vane geometric parameters on the head-flow curve of the multistage pump as turbine. Processes, 11(12), 3393. https://doi.org/10.3390/pr11123393
Wang, Z., Lu, C., Qiu, N., Shi, W., Jiang, X., Feng, Q., & Cao, W. (2018). Experimental study on the unsteady performance of the multistage centrifugal pump. Journal of the Brazilian Society of Mechanical Sciences and Engineering, 40(5), 1-10. https://doi.org/10.1007/ s40430- 018-1157-x, 2-s2.0- 85046084 116.n
Wu, T., Wu, D., Gao, S., Song, Y., Ren, Y., & Mou, J. (2023). Multi-objective optimization and loss analysis of multistage centrifugal pumps, Energy, 284 (2023), 128638. https://doi.org/10.1016/j.energy.2023.128638
Yang, R. Y., Shen, H. C., & Yao, H. Z. (2010). Uncertain analysis of CFD simulation on the open-wa-ter performance of the propeller. Journal of Ship Mechanics, 14(2), 472-480.
Yuan, S. Q., Shi, W. D., & Liu, H. L. (2014). Theory and Technology of Pump. China Machine Press, Beijing.
Zhang, N., Shen, H. C., & Yao, H. Z. (2008). Uncertain analysis in CFD for resistance and flow field. Journal of Ship Mechanics, 12(2), 211-224. https://doi.org/10.3969/j.issn.1007-7294.2008.02.007.
Zhang, L., Wang, D., Yang, G., Pan, Q., Shi, W., & Zhao, R. (2024). Optimization of hydraulic efficiency and internal flow characteristics of a multi-stage pump using RBF neural network. Water, 16(11), 1488. https://doi.org/10.3390/w16111488
Zhang, S., Li, X., & Zhu, Z. (2018). Numerical simulation of cryogenic cavitating flow by an extended transport-based cavitation model with thermal effects. Cryogenics, 92, 98-104. https://doi.org/10.1016/j.cryogenics.2018.04.008
Zhang, Y., Liu, J., Yang, X., Li, H., Chen, S., Lv, W., Xu,W., Zheng J & Wang, D. (2022). Vibration analysis of a high-pressure multistage centrifugal pump. Scientific Reports, 12(1) 20293. https://doi.org/10.1038/s41598-022-22605-2
Zhao, J., Pei, J., Yuan, J., & Wang, W. (2023). Structural optimization of multistage centrifugal pump via computational fluid dynamics and machine learning method. Journal of Computational Design and Engineering, 10(3), 1204-1218. https://doi.org/10.1093/jcde/qwad045
Zhou, L., Bai, L., Li, W., Shi, W., & Wang, C. (2018). PIV validation of different turbulence models used for numerical simulation of a centrifugal pump diffuser. Engineering Computations, 35(1), 2-17. https://doi.org/ 10.1108 /EC-07-2016-0251.
Zhou, R. Z., Liu, H. L., Hua, R. N., Dong, L., Ooi, K. T., Dai, C., & Hu, S. Y. (2023). Induced noise of impeller stuck and passive rotation state in multi-stage pump without power drive under natural flow conditions. Journal of Hydrodynamics, 35(5), 1008-1026. https://doi.org/10.1007/s42241-023-0068-1.